- Colors That Energize
- Remote Control
- Adjustable Brightness
- 5 meter length
- Easy to Install
- Color Type: RGB
- EU plug
Delivery Information
Region |
Estimated date |
Free Shipping condition |
Lebanon |
3-5 days |
ALL orders |
Middle east |
4-5 days |
Orders above 60$ |
Europe |
4-7 days |
Orders above 60$ |
USA |
5-days |
Orders above 60$ |
Australia |
7-15 days |
Orders above 60$ |
Package Includes
Remote Control
Waterproof- Silicone protected
16 Color Choices
Can display one color at a time
Adjust brightness and speed
Unlimited color options
Shows all colors , not just RGB.
Includes White & Warm White
It’s possible for you to cut RGB strip light along the golden marks. If you don't trim at designated cutting points, your light strips may not work.
Note: Only the side of the light strips that are plugged in will light up. The other side will not, they will be thrown away.
We advise you to have a professional cut them if needed, if not its better to avoid that.
It’s not recommended to connect extra strip light because of the power issue. The voltage drop may cause the strip light to show different colors or the last part of the strip light will be off if they are connected continuously.
It's advised to plug other light strips to different plugs to use.
LED strips are flexible but should not be bend laterally. While this is usually not an issue, you may need to turn a corner or otherwise change direction within an LED strip run.
1. Make sure the plastic label is pulled out when you use the remote.
2. The remote should point at the black IR receiver on the control box.
3. Please try to replace a CR2025 battery for the remote.
To open: push the red part to right side and pull out the blue part at the same time.
1. When you are trying to remove the paper, please take it slowly and press the paper back to the tape once the adhesive is going to be ripped off with the protective layer.
2. Please stick the strip lights to a clean and smooth surface.
3. Please use a dust-free cloth to clean the surface of the dust and oil residue, then install the light strip.
4. Do not touch the adhesive side with your fingers. Press for 10-30 seconds after sticking it.
5. The ideal operating temperature of the Tape is about 20ºC and 40ºC